Battery Watt-Hour & Runtime Estimator

1. Select Battery Platform Ecosystem

2. Battery Pack Rated Capacity

3. Tool Application & Continuous Draw

Motor Draw: 320W

80W (Detail sander) 1000W (Table saw) 2200W (Heavy demo)

Estimated Continuous Trigger Time

16.9 Min

Full-throttle continuous operation until low-voltage cutoff. In intermittent real-world trigger pulses, expect 2.5x to 3x longer overall shop coverage.

Pack Nominal Energy 90.0 Wh

Usable Energy (Sag Adjusted) 76.5 Wh

Current Draw at Nominal Volts 17.8 Amps

Thermal Grade Factor Optimized / Safe

Shop Field Insight: 5.0Ah 20V packs are the sweet spot for balance and heat dissipation on brushless framing tools.

Equipment Operating Cost: Cordless Electric vs. 2-Cycle Gas

Real operating cost breakdown for perimeter clearing, trimming, and ongoing equipment maintenance.

1. Equipment Application

2. Mixed Fuel Cost per Gallon (Gas + 50:1 2-Cycle Oil)

3. Electricity Rate ($/kWh, Texas Co-op average is $0.12)

4. Annual Operating Hours

Estimated Annual Fuel & Power Savings

$247.20

Saved each season by running brushless cordless over small 2-cycle gas engines.

Gas Operating Cost / Hr $3.40 / hr

Cordless Electricity / Hr $0.03 / hr

Annual Gas Spend $204.00

Annual Electric Spend $1.80

3-Year Cumulative Savings $741.60

Field Maintenance Reality: Beyond fuel cost savings, cordless eliminates ethanol carburetor gumming, winterizing, spark plug fouling, and fuel stabilizer costs.

How Battery Chemistry Behaves in the Shop

Manufacturer watt-hour ratings printed on the label are theoretical best-case numbers measured at a slow, gentle 0.2C discharge rate in a climate-controlled room. When you lean hard into a 2-inch live oak slab or rip 3/4-inch treated plywood in 95-degree Texas heat, real cell physics take over:

Internal Cell Resistance (IR): High amp draws cause voltage to sag prematurely, tripping the tool's electronic low-voltage cutoff before all stored chemical energy is evacuated.
Pouch Cell / Tabless Advantages: DeWalt PowerStack and Milwaukee Forge packs use stacked planar electrodes rather than coiled jelly-rolls, cutting resistance by up to 50% and keeping heat down under heavy miter or framing saw cuts.
M12 Duty Limits: Compact 12-volt tools are built for maneuverability and precision, not sustained heavy rips. Running a 3.0Ah or 4.0Ah XC pack gives your M12 tools room to breathe without baking the cell wraps.