WORKPRO 8-Inch Nail Puller & End Nipper: Salvage & Demo Power

The Straight-Shooter Take

Pulling stubborn framing nails and brads out of reclaimed barn lumber with a claw hammer often snaps the nail head off or tears a huge chunk out of the face grain. WORKPRO's 8-inch high-leverage end nippers use a curved rocker jaw design that rolls the nail up and out with smooth mechanical leverage rather than brute force.

Fit, Finish & Mechanical Integrity

Forged from high-tensile CR-V steel, the jaws meet flush with tight tolerances. The rounded head acts as a natural fulcrum that multiplies your hand pressure, allowing you to grip flush-embedded headless nails and roll them free without damaging the surrounding wood.

• Rocker Fulcrum: Curved jaw back provides rolling leverage against timber
• Flush Cutting Faces: Ground flat on top to snip protruding wire, fencing clips, and brads flush
• High-Leverage Joint: Pivot point is placed close to the jaw for maximum gripping torque

Real-World Durability Check

1. Barn Wood De-Nailing: Pulled out over 150 rusted 16d nails from reclaimed 2x6 rafters. The rocker nose rolled them out clean with minimal wood damage.
2. Headless Brad Removal: Gripped and pulled 18-gauge brads pulled through trim boards from the back side without snapping.
3. Wire Fencing Snipping: Cut through heavy galvanized pasture tie wire cleanly without leaving burrs on the cutters.

Bottom Line: Keep or Pass?

If you do remodel work, salvage antique lumber, or pull old fencing, this high-leverage nipper is a workhorse that saves valuable wood from getting destroyed.