Fanttik E1 NEX Precision Screwdriver Set: 64 S2 Bits for Micro Fastening
- Dual torque toggle protects delicate M1.6 and M2 micro threads from stripping
- 64 precision CNC-machined S2 steel bits covering Torx Security, Pentalobe, and Tri-Wing
- Pop-up aluminum storage workstation keeps all bits magnetized and organized
- Ring of shadowless LED worklights right at the chuck collar
- Manual spindle lock holds up to 3.0 N.m for loosening factory threadlocker
- Micro torque settings are not suited for standard furniture or wood screws
- Pop-up case spring can stick if fine metal grinding dust gets into the latch
- Bit organizer slots require finger dexterity to extract the smallest 28mm bits
Micro-Torque Control for Precision Diagnostics
Servicing homelab server motherboards, digital calipers, drone electronics, and pocket knives requires an entirely different class of fastening tool. Too much torque instantly shears miniature brass standoffs or strips tiny Torx T4 screws.
The Fanttik E1 NEX Workstation addresses this with dual electronic torque stages: Low torque (0.05 N.m) for eyeglasses, watches, and camera sensors; and High torque (0.20 N.m) for laptop enclosures, game consoles, and electronics chassis.
64 S2 Steel Bits & Magnetic Pop-Up Case
The entire kit resides inside a slick matte-gray aluminum sleeve. Pressing the top pops open a spring-loaded organizer housing 64 precision bits machined from 60 HRC S2 tool steel. The bits are strongly magnetized, holding micro-screws firmly on the tip during blind drops into deep recessed component holes.
Manual Breakaway Strength
When encountering factory blue threadlocker on pocket clip screws or chassis fasteners, the tool's manual spindle lock withstands up to 3.0 N.m of manual twist. You break the Loctite bond by hand, then feather the forward button to spin the screw out at 200 RPM in seconds.
Shop Benchmarks & Specs
| Screws Driven On Single Charge | 420 M2 laptop chassis screws |
| High Torque Cam-Out Rate | 0% across 50 test cycles |
| Bit Hardness Rating | 60.4 HRC measured Rockwell |
| Full Recharge Time | 50 minutes via USB-C |